Datasheet

215
11011B–ATARM–21-Feb-12
SAM3N
Figure 12-6. Watchdog Reset
12.4.5 Reset State Priorities
The Reset State Manager manages the following priorities between the different reset sources,
given in descending order:
• General Reset
• Backup Reset
• Watchdog Reset
• Software Reset
• User Reset
Particular cases are listed below:
• When in User Reset:
– A watchdog event is impossible because the Watchdog Timer is being reset by the
proc_nreset signal.
– A software reset is impossible, since the processor reset is being activated.
• When in Software Reset:
– A watchdog event has priority over the current state.
– The NRST has no effect.
• When in Watchdog Reset:
– The processor reset is active and so a Software Reset cannot be programmed.
– A User Reset cannot be entered.
Only if
WDRPROC = 0
SLCK
periph_nreset
proc_nreset
wd_fault
NRST
(nrst_out)
EXTERNAL RESET LENGTH
8 cycles (ERSTL=2)
MCK
Processor Startup
= 2 cycles
Any
Freq.
RSTTYP
Any
XXX
0x2 = Watchdog Reset