Datasheet

192
11011B–ATARM–21-Feb-12
SAM3N
10.22.1 SysTick Control and Status Register
The SysTick CTRL register enables the SysTick features. See the register summary in Table 10-
33 on page 191 for its attributes. The bit assignments are:
• COUNTFLAG
Returns 1 if timer counted to 0 since last time this was read.
• CLKSOURCE
Indicates the clock source:
0 = MCK/8
1 = MCK
•TICKINT
Enables SysTick exception request:
0 = counting down to zero does not assert the SysTick exception request
1 = counting down to zero to asserts the SysTick exception request.
Software can use COUNTFLAG to determine if SysTick has ever counted to zero.
• ENABLE
Enables the counter:
0 = counter disabled
1 = counter enabled.
When ENABLE is set to 1, the counter loads the RELOAD value from the LOAD register and then counts down. On reach-
ing 0, it sets the COUNTFLAG to 1 and optionally asserts the SysTick depending on the value of TICKINT. It then loads the
RELOAD value again, and begins counting.
31 30 29 28 27 26 25 24
Reserved
23 22 21 20 19 18 17 16
Reserved COUNTFLAG
15 14 13 12 11 10 9 8
Reserved
76543210
Reserved
CLKSOURCE
TICKINT ENABLE