Datasheet

234
ATmega8A [DATASHEET]
8159E–AVR–02/2013
2. “Min” means the lowest value where the pin is guaranteed to be read as high
3. Although each I/O port can sink more than the test conditions (20mA at Vcc = 5V, 10mA at Vcc = 3V) under steady state
conditions (non-transient), the following must be observed:
PDIP, TQFP, and QFN/MLF Package:
1] The sum of all IOL, for all ports, should not exceed 300 mA.
2] The sum of all IOL, for ports C0 - C5 should not exceed 100 mA.
3] The sum of all IOL, for ports B0 - B7, C6, D0 - D7 and XTAL2, should not exceed 200 mA.
If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current greater
than the listed test condition.
4. Although each I/O port can source more than the test conditions (20 mA at Vcc = 5V, 10 mA at Vcc = 3V) under steady state
conditions (non-transient), the following must be observed:
PDIP, TQFP, and QFN/MLF Package:
1] The sum of all IOH, for all ports, should not exceed 300 mA.
2] The sum of all IOH, for port C0 - C5, should not exceed 100 mA.
3] The sum of all IOH, for ports B0 - B7, C6, D0 - D7 and XTAL2, should not exceed 200 mA.
If IOH exceeds the test condition, VOH may exceed the related specification. Pins are not guaranteed to source current
greater than the listed test condition.
Note: 1. The current consumption values include input leakage current.
27.1.1 ATmega8A DC Characteristics
Table 27-1. T
A
= -40C to 105C, V
CC
= 1.8V to 5.5V (unless otherwise noted)
Symbol Parameter Condition Min. Typ. Max. Units
I
CC
Power Supply Current
Active 4 MHz, V
CC
= 3V 6 mA
Active 8 MHz, V
CC
= 5V 15 mA
Idle 4 MHz, V
CC
= 3V 3 mA
Idle 8 MHz, V
CC
= 5V 8 mA
Power-down mode
(1)
WDT enabled, V
CC
= 3V 35 µA
WDT disabled, V
CC
= 3V 6 µA