Datasheet

3Atmel ATmega16M1/32M1/32C1/64M1/64C1 Automotive [DATASHEET]
7781E–AVR–03/12
Output Low Voltage
(3)
,
I/O pin except RESET
I
OL
= 10mA, V
CC
= 5V V
OL
0.8 V
Output High Voltage
(4)
,
I/O pin except RESET
I
OH
= –10mA, V
CC
= 5V V
OH
4.1 V
Output High Voltage
(Reset pin)
I
OH
= 0.6mA, V
CC
= 5V V
OH3
3 V
Input Leakage
Current I/O Pin
V
CC
= 5.5V, pin low
(absolute value)
I
IL
1 µA
Input Leakage
Current I/O Pin
V
CC
= 5.5V, pin high
(absolute value)
I
IH
1 µA
Reset Pull-up Resistor R
RST
30 200 kΩ
I/O Pin Pull-up Resistor R
PU
20 50 kΩ
Power Supply Current
(4)
Active 16MHz, V
CC
= 5V,
External Clock, PRR = 0xFF,
I
CC
14 30 mA
Idle 16MHz, V
CC
= 5V,
External Clock
I
CC IDLE
5.5 15 mA
Power-down mode
WDT enabled, V
CC
= 5V
I
CC PWD
80 330 µA
WDT disabled, V
CC
= 5V 70 310 µA
Analog Comparator
Input Leakage Current
V
CC
= 5V
V
in
= V
CC
/2
I
ACLK
–200 +200 nA
1.2 DC Characteristics (Continued)
T
A
= –40°C to +150°C, V
CC
= 4.5V to 5.5V (unless otherwise noted)
Parameters Test Conditions Symbol Min. Typ. Max. Unit
Notes: 1. “Max” means the highest value where the pin is guaranteed to be read as low
2. “Min” means the lowest value where the pin is guaranteed to be read as high
3. Although each I/O port can sink more than the test conditions (20mA at V
CC
= 5V) under steady state conditions (non-
transient), the following must be observed:
1] The sum of all IOL, for all ports, should not exceed 400mA.
2] The sum of all IOL, for ports C0 - C5, should not exceed 200mA.
3] The sum of all IOL, for ports C6, D0 - D4, should not exceed 300mA.
4] The sum of all IOL, for ports B0 - B7, D5 - D7, should not exceed 300mA.
If IOL exceeds the test condition, VOL may exceed the related specification. Pins are not guaranteed to sink current
greater than the listed test condition.
4. For temperature range +125°C to +150°C only. For –40°C to +125°C, refer to
ATmega16M1/ATmega32M1/ATmega32C1/ATmega64M1/ATmega64C1 Automotive datasheet.