Datasheet

22
8042ES–AVR–09/2013
ATmega16HVB/32HVB
12.3 Rev. 8042C-06/2011
23. In Table 32-18 on page 236 the maximum value for t
WLRH_CE
has been corrected
24. The former figure “Active supply current vs. V
VFET
, WDT, V
REF
, CBP, OC/OD and CC-ADC
enabled” on page 238 has been removed
25. In Table 33-1 on page 243 the text “CC-OD” has benn changed to “OC-OD” and below “Typical
current consumption” the value “55µA” has been changed to “85µA”
26. New text is added below the two notes for Table 33-1 on page 243
27. New Figure 33-11 on page 245 “Power-save supply current vs. V
VFET
, WDT, V
REF
, CBP, OC/OD,
and CC-ADC enabled” is added
28. The plot in Figure 33-13 on page 246 has been updated
29. The plot in Figure 33-14 on page 246 has been updated
30. New Figure 33-15 on page 247 has been added
31. New Figure 33-21 on page 250 has been added
32. Heading in Figure 33-27 on page 253 has been corrected
33. The power supply voltage in the table in Section 9.1 on page 16 has been corrected
34. The power supply voltage in the table in Section 9.2 on page 17 has been corrected
35. The Section 11. on page 19 has been corrected by adding an errata for “all revisions”
36. The text “...clock period of the Slow RC Oscillator...” in point 2 in Section 9.2.3 on page 27 has
been corrected to “...clock period of the ULP RC Oscillator...”
37. Note 1 below Table 19-1 on page 112 has been corrected
38. Note 1 below Table 19-2 on page 112 has been corrected
39. Figure 31-1 on page 220 has been updated
40. Figure 31-2 on page 221 has been updated
41. Figure 31-3 on page 222 has been updated
42. Table 31-1 on page 223 has been updated according to the changes in Figure 31-1 on page
220, Figure 31-2 on page 221, and Figure 31-3 on page 222
1. The columns “Minimum” and “Maximum” in Table 24-5 on page 142 are deleted
2. A new row (“Device lot ID and position”) in Table 29-3 on page 196 is added
3. A new note (“Note 16”) in Table 29-3 on page 196 is added
4. In ”Absolute maximum ratings*” on page 225 the following values have been changed: “Voltage
on OC and OD with respect to ground”, “Voltage on PC5, BATT, PVT, VFET, PV4, PV3, and PV2
with respect to ground”, and “Maximum operating voltage on VFET”
5. In Table 32-1 on page 225 the values for “Typical” and “Maximum” in the row “VFET = 16V,
WDT, CC-ADC, OC, OD, and battery protection enabled, DUVR mode disabled” are added
6. “Frequency drift” for “Slow RC oscillator” in Table 32-8 on page 229 is deleted
7. A new note (“Note 4”) in Table 32-8 on page 229 is added
8. Table 32-10 on page 230 is updated and corrected