Datasheet

17
8155CS–AVR–02/11
ATmega32A
10. Datasheet Revision History
Please note that the referring page numbers in this section are referred to this document. The
referring revision in this section are referring to the document revision.
10.1 Rev. 8155C – 02/11
10.2 Rev. 8155B – 07/09
10.3 Rev. 8155A – 06/08
1. Updated the datashee according to the Atmel new brand style guide (new logo, last page, etc).
2. Inserted note in “Performing Page Erase by SPM” on page 259 .
3.
Note 6 and Note 7 below Table 27-2, “Two-wire Serial Bus Requirements,” on page 301 have
been removed.
4. Updated “Ordering Information” on page 340 to include Tape & Reel and 105°C devices.
5. Updated all “Typical Characteristics”
1. Updated “Errata” on page 343.
2. Updated the last page with Atmel’s new addresses.
1. Initial revision (Based on the ATmega32/L datasheet 2503N-AVR-06/08)
Changes done compared ATmega32/L datasheet 2503N-AVR-06/08:
- Updated description in “Stack Pointer” on page 11.
- All Electrical characteristics is moved to “Electrical Characteristics” on page 296.
- Register descriptions are moved to sub sections at the end of each chapter.
- Test limits of Reset Pull-up Resistor (R
RST
) in “DC Characteristics” on page 296.
- New graphs in “Typical Characteristics” on page 306.
- New “Ordering Information” on page 339.