Manualshelf

Datasheet

ManualsBrandsMICROCHIP TECHNOLOGY ManualsMicrocontrollers, Microprocessors & QuartzesEmbedded microcontroller TSSOP 44 8-Bit 8 MHz I/O number 17
15161718192021222324
21
8042ES–AVR–09/2013
ATmega16HVB/32HVB
12. Revision history
Please note that the referring page numbers in this section are referring to this document. The
referring revision in this section are referring to the document revision.
12.1 Rev. 8042E-09/2013
12.2 Rev. 8042D-10/2011
1. Updated ”Errata” on page 19:
ATmega16HVB: Added errata sections for “Rev. C” , “Rev. D” and “Rev. E” .
ATmega32HVB: Added errata sections for “Rev. B” , “Rev. C” , “Rev. D” and “Rev. E” .
1. Operating voltage has been changed from 4V - 25V to 4V - 18V
2. The methods for determing the actual clock period of the ULP Oscillator i Section 9.2.3 on page
27 have been changed
3. In ”Bit 1:0 – CLKPS[1:0]: Clock Prescaler select Bit[1:0]” on page 33 new text has been inserted
in and the text “If CKDIBV8 is programmed” has been corrected to “If CKDIV8 is programmed”
4. Note 2 in ”Bit 0 – OSIEN: Oscillator sampling interface enable” on page 34 has been deleted
5. Figure 11-1 on page 43 has been corrected
6. New Note 2 has been added below Table 11-2 on page 51
7. The last sentence in Section 21.5 on page 123 has been corrected
8. The text in Section 25.3.1 on page 146 below Figure 25-2 has been corrected several places
9. V
CC
in Figure 28-1 on page 186 has been corrected
10. Bit no 4 in Table 30-3 on page 205 has been corrected
11. Note 1 below Table 30-3 on page 205 has been corrected
12. The text in point 4 and 5 in Section 30.6.1 on page 208 has been corrected
13. The V
FET
value in Figure 30-3 on page 212 has been corrected
14. The table in Section 32.1 on page 225 hase been updated with several new values
15. I
LOAD
in Table 32-2 on page 226 has been added
16. Note 1 below Table 32-2 on page 226 has been added
17. The maximum value for V
BOT
in Table 32-3 on page 227 has been added
18. In Table 32-4 on page 227 the maximum value for V
RSCL
has been corrected and the maximum
value for V
REG
pin has been added
19. In Table 32-7 on page 229 the typical and maximum values for INL has been corrected
20. In Table 32-8 on page 229 the typical value for frequency prediction error (slow RC oscillator)
has been corrected
21. In Table 32-10 on page 230 the text below “Parameter” has been corrected
22. In Table 32-12 on page 231 Note 5 has been added