Datasheet

247
8018P–AVR–08/10
ATmega169P
• Bit 0 – LCDBL: LCD Blanking
When this bit is written to one, the display will be blanked after completion of a frame. All seg-
ment and common pins will be driven to ground.
23.5.2 LCDCRB – LCD Control and Status Register B
• Bit 7 – LCDCS: LCD Clock Select
When this bit is written to zero, the system clock is used. When this bit is written to one, the
external asynchronous clock source is used. The asynchronous clock source is either
Timer/Counter Oscillator or external clock, depending on EXCLK in ASSR. See ”Asynchronous
operation of the Timer/Counter” on page 150 for further details.
• Bit 6 – LCD2B: LCD 1/2 Bias Select
When this bit is written to zero, 1/3 bias is used. When this bit is written to one, ½ bias is used.
Refer to the LCD Manufacture for recommended bias selection.
• Bit 5:4 – LCDMUX1:0: LCD Mux Select
The LCDMUX1:0 bits determine the duty cycle. Common pins that are not used are ordinary port
pins. The different duty selections are shown in Table 23-2.
Note: 1. 1/2 bias when LCD2B is written to one and 1/3 otherwise.
• Bit 3 – Res: Reserved Bit
This bit is reserved and will always read as zero.
• Bits 2:0 – LCDPM2:0: LCD Port Mask
The LCDPM2:0 bits determine the number of port pins to be used as segment drivers. The dif-
ferent selections are shown in Table 23-3. Unused pins can be used as ordinary port pins.
Bit 765 4 3210
(0xE5)
LCDCS LCD2B LCDMUX1 LCDMUX0 – LCDPM2 LCDPM1 LCDPM0 LCDCRB
Read/Write R/W R/W R/W R/W R R/W R/W R/W
Initial Value000 0 0000
Table 23-2. LCD Duty Select
LCDMUX1 LCDMUX0 Duty Bias COM Pin I/O Port Pin
0 0 Static Static COM0 COM1:3
0 1 1/2 1/2 or 1/3
(1)
COM0:1 COM2:3
101/31/2
or 1/3
(1)
COM0:2 COM3
111/41/2
or 1/3
(1)
COM0:3 None
Table 23-3. LCD Port Mask
LCDPM2 LCDPM1 LCDPM0
I/O Port in Use as Segment
Driver
Maximum Number of
Segments
0 0 0 SEG0:12 13
0 0 1 SEG0:14 15
0 1 0 SEG0:16 17
0 1 1 SEG0:18 19