Datasheet

129

8018P–AVR–08/10

ATmega169P

Table 15-3 shows the COM1x1:0 bit functionality when the WGM13:0 bits are set to the phase

correct or the phase and frequency correct, PWM mode.

Note: 1. A special case occurs when OCR1A/OCR1B equals TOP and COM1A1/COM1B1 is set. See

”Phase Correct PWM Mode” on page 122. for more details.

• Bit 1:0 – WGM11:0: Waveform Generation Mode

Combined with the WGM13:2 bits found in the TCCR1B Register, these bits control the counting

sequence of the counter, the source for maximum (TOP) counter value, and what type of wave-

form generation to be used, see Table 15-4 on page 130. Modes of operation supported by the

Timer/Counter unit are: Normal mode (counter), Clear Timer on Compare match (CTC) mode,

and three types of Pulse Width Modulation (PWM) modes. (See ”Modes of Operation” on page

118.)

Table 15-3. Compare Output Mode, Phase Correct and Phase and Frequency Correct

PWM

(1)

COM1A1/COM1B1 COM1A0/COM1B0 Description

0 0 Normal port operation, OC1A/OC1B disconnected.

WGM13:0 = 9 or 11: Toggle OC1A on Compare

Match, OC1B disconnected (normal port operation).

For all other WGM1 settings, normal port operation,

OC1A/OC1B disconnected.

Clear OC1A/OC1B on Compare Match when up-

counting. Set OC1A/OC1B on Compare Match when

down counting.

Set OC1A/OC1B on Compare Match when up-

counting. Clear OC1A/OC1B on Compare Match

when down counting.