Datasheet

304
2545T–AVR–05/11
ATmega48/88/168
Notes: 1. “Max” means the highest value where the pin is guaranteed to be read as low
2. “Min” means the lowest value where the pin is guaranteed to be read as high
3. Although each I/O port can sink more than the test conditions (20mA at V
CC
= 5V, 10mA at V
CC
= 3V) under steady state
conditions (non-transient), the following must be observed:
ATmega48/88/168:
1] The sum of all I
OL
, for ports C0 - C5, ADC7, ADC6 should not exceed 100mA.
2] The sum of all I
OL
, for ports B0 - B5, D5 - D7, XTAL1, XTAL2 should not exceed 100mA.
3] The sum of all I
OL
, for ports D0 - D4, RESET should not exceed 100mA.
If I
OL
exceeds the test condition, V
OL
may exceed the related specification. Pins are not guaranteed to sink current greater
than the listed test condition.
4. Although each I/O port can source more than the test conditions (20mA at V
CC
= 5V, 10mA at V
CC
= 3V) under steady state
conditions (non-transient), the following must be observed:
ATmega48/88/168:
1] The sum of all I
OH
, for ports C0 - C5, D0- D4, ADC7, RESET should not exceed 150mA.
2] The sum of all I
OH
, for ports B0 - B5, D5 - D7, ADC6, XTAL1, XTAL2 should not exceed 150mA.
If II
OH
exceeds the test condition, V
OH
may exceed the related specification. Pins are not guaranteed to source current
greater than the listed test condition.
5. Values with “Minimizing power consumption” on page 41 enabled (0xFF).
I
CC
Power supply current
(5)
Active 1MHz, V
CC
= 2V
(Atmel ATmega48/88/168V)
0.55
mA
Active 4MHz, V
CC
= 3V
(Atmel ATmega48/88/168L)
3.5
Active 8MHz, V
CC
= 5V
(Atmel ATmega48/88/168)
12
Idle 1MHz, V
CC
= 2V
(ATmega48/88/168V)
0.25 0.5
Idle 4MHz, V
CC
= 3V
(ATmega48/88/168L)
1.5
Idle 8MHz, V
CC
= 5V
(ATmega48/88/168)
5.5
Power-down mode
WDT enabled, V
CC
= 3V 8 15
µA
WDT disabled, V
CC
= 3V 1 2
V
ACIO
Analog comparator
input offset voltage
V
CC
= 5V
V
in
= V
CC
/2
10 40 mV
I
ACLK
Analog comparator
input leakage current
V
CC
= 5V
V
in
= V
CC
/2
-50 50 nA
t
ACID
Analog comparator
propagation delay
V
CC
= 2.7V
V
CC
= 4.0V
750
500
ns
T
A
= -40°C to 85°C, V
CC
= 1.8V to 5.5V (unless otherwise noted). (Continued)
Symbol Parameter Condition Minimum Typical Maximum Units