Datasheet

18
ATmega16(L)
2466LS–AVR–06/05
14. Added section “EEPROM Write During Power-down Sleep Mode” on page 20.
15. Added note about Differential Mode with Auto Triggering in “Prescaling and
Conversion Timing” on page 205.
16. Added updated “Packaging Information” on page 12.
Rev. 2466E-10/02 1. Updated “DC Characteristics” on page 291.
Rev. 2466D-09/02 1. Changed all Flash write/erase cycles from 1,000 to 10,000.
2. Updated the following tables: Table 4 on page 24, Table 15 on page 36, Table
42 on page 83, Table 45 on page 110, Table 46 on page 110, Table 59 on page
141, Table 67 on page 165, Table 90 on page 234, Table 102 on page 258, “DC
Characteristics” on page 291, Table 119 on page 293, Table 121 on page 295,
and Table 122 on page 297.
3. Updated “Errata” on page 15.
Rev. 2466C-03/02 1. Updated typical EEPROM programming time, Table 1 on page 18.
2. Updated typical start-up time in the following tables:
Table 3 on page 23, Table 5 on page 25, Table 6 on page 26, Table 8 on page 27,
Table 9 on page 27, and Table 10 on page 28.
3. Updated Table 17 on page 41 with typical WDT Time-out.
4. Added Some Preliminary Test Limits and Characterization Data.
Removed some of the TBD's in the following tables and pages:
Table 15 on page 36, Table 16 on page 40, Table 116 on page 272 (table removed
in document review #D), “Electrical Characteristics” on page 291, Table 119 on
page 293, Table 121 on page 295, and Table 122 on page 297.
5. Updated TWI Chapter.
Added the note at the end of the “Bit Rate Generator Unit” on page 176.
6. Corrected description of ADSC bit in “ADC Control and Status Register A –
ADCSRA” on page 217.
7. Improved description on how to do a polarity check of the ADC doff results in
“ADC Conversion Result” on page 214.
8. Added JTAG version number for rev. H in Table 87 on page 227.
9. Added not regarding OCDEN Fuse below Table 105 on page 260.
10. Updated Programming Figures:
Figure 127 on page 262 and Figure 136 on page 274 are updated to also reflect that
AVCC must be connected during Programming mode. Figure 131 on page 270
added to illustrate how to program the fuses.