Datasheet

62
2466T–AVR–07/10
ATmega16(L)
• SDA – Port C, Bit 1
SDA, Two-wire Serial Interface Data: When the TWEN bit in TWCR is set (one) to enable the
Two-wire Serial Interface, pin PC1 is disconnected from the port and becomes the Serial Data
I/O pin for the Two-wire Serial Interface. In this mode, there is a spike filter on the pin to sup-
press spikes shorter than 50 ns on the input signal, and the pin is driven by an open drain driver
with slew-rate limitation. When this pin is used by the Two-wire Serial Interface, the pull-up can
still be controlled by the PORTC1 bit.
• SCL – Port C, Bit 0
SCL, Two-wire Serial Interface Clock: When the TWEN bit in TWCR is set (one) to enable the
Two-wire Serial Interface, pin PC0 is disconnected from the port and becomes the Serial Clock
I/O pin for the Two-wire Serial Interface. In this mode, there is a spike filter on the pin to sup-
press spikes shorter than 50 ns on the input signal, and the pin is driven by an open drain driver
with slew-rate limitation. When this pin is used by the Two-wire Serial Interface, the pull-up can
still be controlled by the PORTC0 bit.
Table 29 and Table 30 relate the alternate functions of Port C to the overriding signals shown in
Figure 26 on page 55.
Table 29. Overriding Signals for Alternate Functions in PC7..PC4
Signal
Name PC7/TOSC2 PC6/TOSC1 PC5/TDI PC4/TDO
PUOE AS2 AS2 JTAGEN JTAGEN
PUOV 0 0 1 0
DDOE AS2 AS2 JTAGEN JTAGEN
DDOV 0 0 0 SHIFT_IR + SHIFT_DR
PVOE 0 0 0 JTAGEN
PVOV 0 0 0 TDO
DIEOE AS2 AS2 JTAGEN JTAGEN
DIEOV 0 0 0 0
DI – – – –
AIO T/C2 OSC OUTPUT T/C2 OSC INPUT TDI –