Manualshelf

User manual

ManualsBrandsMICROCHIP TECHNOLOGY ManualsDev KitsPCB design board
1234
AVR32 EVK1100 Getting Started Guide -2
7713A–AVR32–05/07
The next step is to access the Control Panel through its web server with a direct point-
to-point connection between a PC and the EVK1100 board.
Configuring the PC
network port to local
mode (Windows XP)
Most computers are setup to use dynamic IP addresses. To directly connect the
EVK1100 to a PC, the network interface of the PC must be configured to use a static IP
address. The goal of this section is to perform such a configuration.
Step 1: Select Start−>Settings−>Network Connections.
Step 2: Right-click on the network connection where the EVK1100 will be plugged to
and select Properties. There may be several defined connections on the PC: the
connection associated with the Ethernet port of the PC must be selected.