Datasheet

676
SAM9X25 [DATASHEET]
11054E–ATARM–10-Mar-2014
35.8.2 SPI Mode Register
Name: SPI_MR
Address: 0xF0000004 (0), 0xF0004004 (1)
Access: Read-write
This register can only be written if the WPEN bit is cleared in ”SPI Write Protection Mode Register”.
• MSTR: Master/Slave Mode
0 = SPI is in Slave mode.
1 = SPI is in Master mode.
• PS: Peripheral Select
0 = Fixed Peripheral Select.
1 = Variable Peripheral Select.
• PCSDEC: Chip Select Decode
0 = The chip selects are directly connected to a peripheral device.
1 = The four chip select lines are connected to a 4- to 16-bit decoder.
When PCSDEC equals one, up to 15 Chip Select signals can be generated with the four lines using an external 4- to 16-bit
decoder. The Chip Select Registers define the characteristics of the 15 chip selects according to the following rules:
SPI_CSR0 defines peripheral chip select signals 0 to 3.
SPI_CSR1 defines peripheral chip select signals 4 to 7.
SPI_CSR2 defines peripheral chip select signals 8 to 11.
SPI_CSR3 defines peripheral chip select signals 12 to 14.
• MODFDIS: Mode Fault Detection
0 = Mode fault detection is enabled.
1 = Mode fault detection is disabled.
• WDRBT: Wait Data Read Before Transfer
0 = No Effect. In master mode, a transfer can be initiated whatever the state of the Receive Data Register is.
1 = In Master Mode, a transfer can start only if the Receive Data Register is empty, i.e. does not contain any unread data. This
mode prevents overrun error in reception.
• LLB: Local Loopback Enable
0 = Local loopback path disabled.
1 = Local loopback path enabled.
31 30 29 28 27 26 25 24
DLYBCS
23 22 21 20 19 18 17 16
–––– PCS
15 14 13 12 11 10 9 8
––––––––
76543210
LLB – WDRBT MODFDIS – PCSDEC PS MSTR