Datasheet

448
SAM9X25 [DATASHEET]
11054E–ATARM–10-Mar-2014
 00 = Power-down mode is enabled as soon as the SDRAM device is not selected
 01 = Power-down mode is enabled 64 clock cycles after completion of the last access
 10 = Power-down mode is enabled 128 clock cycles after completion of the last access
Figure 30-22.Power-down Entry/Exit, Timeout = 0
30.5.4.3 Deep Power-down Mode
The deep power-down mode is a new feature of the Low-power SDRAM. When this mode is activated, all internal voltage
generators inside the device are stopped and all data is lost.
This mode is activated by setting the low-power command bits [LPCB] to ‘11’. When this mode is enabled, the
DDRSDRC leaves normal mode (mode == 000) and the controller is frozen. To exit deep power-down mode, the low-
power bits (LPCB) must be set to “00”, an initialization sequence must be generated by software. See Section 30.4.2
“Low-power DDR1-SDRAM Initialization” on page 432.
Figure 30-23.Deep Power-down Mode Entry
Entry power down mode
Exit power down mode
SDCLK
A[12:0]
READ BST NOP READ
COMMAND
CKE
0
BA[1:0]
DQS[1:0]
Da Db
D[15:0]
3
DM[1:0]
NOP READ BST NOP PRCHG NOP DEEPOWER NOP
0
Trp
Enter Deep
Power-down
Mode
SDCLK
A[12:0]
COMMAND
CKE
BA[1:0]
DQS[1:0]
Da Db
D[15:0]
3
DM[1:0]