Datasheet

26
6289CS–ATARM–28-May-09
AT91SAM9R64/RL64
• Boot with the default configuration for the Static Memory Controller, byte select mode, 16-bit
data bus, Read/Write controlled by Chip Select, allows boot on 16-bit non-volatile memory.
For optimization purposes, nothing else is done. To speed up the boot sequence user pro-
grammed software should perform a complete configuration:
• Enable the 32768 Hz oscillator if best accuracy needed
• Program the PMC (main oscillator enable or bypass mode)
• Program and Start the PLL
• Reprogram the SMC setup, cycle, hold, mode timings registers for CS0 to adapt them to the
new clock
• Switch the main clock to the new value
8.2 External Memories
The AT91SAM9R64/RL64 features one External Bus Interface to offer interface to a wide range
of external memories and to any parallel peripheral.
8.2.1 External Bus Interface
• Integrates three External Memory Controllers:
– Static Memory Controller
– SDRAM Controller
– SLC Nand Flash ECC Controller
• Additional logic for NAND Flash
and CompactFlash
TM
• Optional Full 32-bit External Data Bus
• Up to 26-bit Address Bus (up to 64MBytes linear per chip select)
• Up to 6 chips selects, Configurable Assignment:
– Static Memory Controller on NCS0
– SDRAM Controller (SDCS) or Static Memory Controller on NCS1
– Static Memory Controller on NCS2
– Static Memory Controller on NCS3, Optional NAND Flash support
– Static Memory Controller on NCS4 - NCS5, Optional CompactFlash
M
support
8.2.2 Static Memory Controller
• 8-, 16- or 32-bit Data Bus
• Multiple Access Modes supported
– Byte Write or Byte Select Lines
– Asynchronous read in Page Mode supported (4- up to 32-byte page size)
• Multiple device adaptability
– Control signals programmable setup, pulse and hold time for each Memory Bank
• Multiple Wait State Management
– Programmable Wait State Generation
– External Wait Request
– Programmable Data Float Time
• Slow Clock mode supported