Datasheet

575
SAM9M10 [DATASHEET]
6355F–ATARM–12-Mar-13
32.10.5.6 Clock Synchronization in Write Mode
The clock is tied low if the shift register and the TWI_RHR is full. If a STOP or REPEATED_START condition was
not detected, it is tied low until TWI_RHR is read.
Figure 32-29 on page 575 describes the clock synchronization in Read mode.
Figure 32-29. Clock Synchronization in Write Mode
Notes: 1. At the end of the read sequence, TXCOMP is set after a STOP or after a REPEATED_START + an address different from
SADR.
2. SCLWS is automatically set when the clock synchronization mechanism is started and automatically reset when the mecha-
nism is finished.
R d DATA 0
R d DATA 1
R d DATA 2
SVACC
SVREAD
RXRDY
SCLWS
TXCOMP
DATA1
DATA2
SCL is stretched on the last bit of DATA1
As soon as a START is detected
TWCK
TWD
TWI_RHR
CLOCK is tied low by the TWI as long as RHR is full
DATA0 is not read in the RHR
ADRS SADR W ADATA 0A A DATA 2DATA1 S
NA