Datasheet

571
SAM9M10 [DATASHEET]
6355FATARM12-Mar-13
32.10.4.2 Write Sequence
In the case of a Write sequence (SVREAD is low), the RXRDY (Receive Holding Register Ready) flag is set as
soon as a character has been received in the TWI_RHR (TWI Receive Holding Register). RXRDY is reset when
reading the TWI_RHR.
TWI continues receiving data until a STOP condition or a REPEATED_START + an address different from SADR
is detected. Note that at the end of the write sequence TXCOMP flag is set and SVACC reset.
See Figure 32-26 on page 573.
32.10.4.3 Clock Synchronization Sequence
In the case where TWI_THR or TWI_RHR is not written/read in time, TWI performs a clock synchronization.
Clock stretching information is given by the SCLWS (Clock Wait state) bit.
See Figure 32-28 on page 574 and Figure 32-29 on page 575.
32.10.4.4 General Call
In the case where a GENERAL CALL is performed, GACC (General Call ACCess) flag is set.
After GACC is set, it is up to the programmer to interpret the meaning of the GENERAL CALL and to decode the
new address programming sequence.
See Figure 32-27 on page 573.