Datasheet

33
SAM9G25 [DATASHEET]
11032C–ATARM–25-Jan-13
8. Peripherals
8.1 Peripheral Mapping
As shown in Figure 6-1, the Peripherals are mapped in the upper 256 Mbytes of the address space between the
addresses 0xF000_0000 and 0xFFFF_C000.
Each User Peripheral is allocated 16 Kbytes of address space.
8.2 Peripheral Identifiers
Table 8-1 defines the Peripheral Identifiers of the SAM9G25. A peripheral identifier is required for the control of the
peripheral interrupt with the Advanced Interrupt Controller and for the control of the peripheral clock with the Power
Management Controller.
Table 8-1. Peripheral Identifiers
Instance
ID
Instance
Name
Instance Description External
interrupt
Wired-OR interrupt
0AICAdvanced Interrupt Controller FIQ
1 SYS System Controller Interrupt
DBGU, PMC, SYSC, PMECC,
PMERRLOC, RTSC, SHDC, PIT
WDT, RTC
2PIOA,PIOBParallel I/O Controller A and B
3PIOC,PIODParallel I/O Controller C and D
4SMDSMD Soft Modem
5USART0USART 0
6USART1USART 1
7USART2USART 2
8USART3USART 3
9TWI0Two-Wire Interface 0
10 TWI1 Two-Wire Interface 1
11 TWI2 Two-Wire Interface 2
12 HSMCI0
High Speed Multimedia Card
Interface 0
13 SPI0 Serial Peripheral Interface 0
14 SPI1 Serial Peripheral Interface 1
15 UART0 UART 0
16 UART1 UART 1
17 TC0,TC1 Timer Counter 0,1,2,3,4,5
18 PWM
Pulse Width Modulation
Controller
19 ADC ADC Controller
20 DMAC0 DMA Controller 0
21 DMAC1 DMA Controller 1
22 UHPHS USB Host High Speed