Datasheet

1092
SAM9G25 [DATASHEET]
11032C–ATARM–25-Jan-13
ADC:
Section 40.7.15 “ADC Compare Window Register”, added two paragraphs about programming LOWTHRES and
HIGHTHRES bitfields depending on the LOWRES bitfield settings (ADC Mode Register).
Section 40.6.4 “Conversion Results”, removed “...and EOC bit corresponding to the last converted channel” from
the last phrase of the third paragraph.
Section 40.2 “Embedded Characteristics”, added the value of Conversion Rate in the 2nd line.
8045
8357
8385
SSC:
Section 43.7.1.1 “Clock Divider”, removed Table 43-4 related to Figure 43-5 “Divided Clock Generation”
(duplicated data in Section 43.7.1.4 “Serial Clock Ratio Considerations”).
Section 43.6.3 “Interrupt”, replaced AIC references with “interrupt controller”.
Section 43.9 “Synchronous Serial Controller (SSC) User Interface”:
- updated descriptions of CKS, CKO, and CKG bitfields in:
Section 43.9.3 “SSC Receive Clock Mode Register”
Section 43.9.5 “SSC Transmit Clock Mode Register”
- updated register tables and a description of FSOS bitfield in:
Section 43.9.4 “SSC Receive Frame Mode Register”
Section 43.9.6 “SSC Transmit Frame Mode Register”
Section 43.9.14 “SSC Interrupt Enable Register”, fixed a typo (0=0= --> 0=).
7303
8466
ISI:
Section 44.5 “Image Sensor Interface (ISI) User Interface”, DMA_xxx acronyms updated to ISI_DMA_xxx.
Section 44.5.1 “ISI Configuration 1 Register”, replaced the description of “THMASK: Threshold Mask” with the
corresponding table.
In the registers cited below, bitfields 7, 15, 23 are not used (7 bit lengths).
Section 44.5.7 “ISI Color Space Conversion RGB to YCrCb Set 0 Register”
Section 44.5.8 “ISI Color Space Conversion RGB to YCrCb Set 1 Register”
Section 44.5.9 “ISI Color Space Conversion RGB to YCrCb Set 2 Register”
7423
Electrical Characteristics:
Added Section 46.12 “USB Transceiver Characteristics” (extracted from SAM9G15 - 11052C: Section 45.12 USB
Transceiver Characteristics).
Section 46.5 “Main Oscillator Characteristics”, replaced minimum CCRYSTAL value of 17.5 with 15 in Table 46-7
“Main Oscillator Characteristics” and in the corresponding note. Updated the related values in the same note.
Section 46.5.1 “Crystal Oscillator Characteristics”, added maximum and minimum CCRYSTAL values for ESR in
Table 46-8 “Crystal Characteristics”.
Section 46.2 “DC Characteristics”, updated RPULLUP parameter characteristics in Table 46-2 “DC
Characteristics”.
Replaced “Input Leakage Current” with “Input Peak Current” in Table 46-26 “Analog Inputs”.
8016
8098
8147
rfo
Mechanical Overview:
Updated the table title in Table 47-4 “Package Information”.8186
Errata:
Section 49.1 “External Bus Interface (EBI)”, updated the problem description and fix/ workaround.
Removed sections concerning PIO and RTC.
Added Section 49.2 “Reset Controller (RSTC)”, Section 49.3 “Static Memory Controller (SMC)”, and Section 49.4
“USB High Speed Host Port (UHPHS) and Device Port (UDPHS)”.
8250
Doc. Rev.
11032B
Comments Change
Request
Ref.