Datasheet
1089
SAM9G25 [DATASHEET]
11032C–ATARM–25-Jan-13
Section 31.7.2 “DMAC Enable Register”, Section 31.7.15 “DMAC Channel x [x = 0..7] Descriptor Address
Register”, Section 31.7.16 “DMAC Channel x [x = 0..7] Control A Register”, and Section 31.7.17 “DMAC Channel
x [x = 0..7] Control B Register”, added respectively descriptions of the following bitfields:
- “ENABLE: General Enable of DMA”
- “DSCR_IF: Descriptor Interface Selection”
- “DONE: Current Descriptor Stop Command and Transfer Completed Memory Indicator”
- “IEN: Interrupt Enable Not”
Updated the last paragraph in Section 31.4.4.3 “Ending Multi-buffer Transfers”.
rfo
8441
UDPHS:
Section 32.4 “Typical Connection”, completed a note below Figure 32-2 “Board Schematic”.
Section 32.7 “USB High Speed Device Port (UDPHS) User Interface”, removed duplicated names in fields and
created separated view for UDPHS Control and Status Registers in:
- Section 32.7.9 “UDPHS Endpoint Control Enable Register (Control, Bulk, Interrupt Endpoints)”
- Section 32.7.10 “UDPHS Endpoint Control Enable Register (Isochronous Endpoints)”
- Section 32.7.11 “UDPHS Endpoint Control Disable Register (Control, Bulk, Interrupt Endpoints)”
- Section 32.7.12 “UDPHS Endpoint Control Disable Register (Isochronous Endpoint)”
- Section 32.7.13 “UDPHS Endpoint Control Register (Control, Bulk, Interrupt Endpoints)”
- Section 32.7.14 “UDPHS Endpoint Control Register (Isochronous Endpoint)”
- Section 32.7.15 “UDPHS Endpoint Set Status Register (Control, Bulk, Interrupt Endpoints)”
- Section 32.7.16 “UDPHS Endpoint Set Status Register (Isochronous Endpoint)”
- Section 32.7.17 “UDPHS Endpoint Clear Status Register (Control, Bulk, Interrupt Endpoints)”
- Section 32.7.18 “UDPHS Endpoint Clear Status Register (Isochronous Endpoint)”
- Section 32.7.19 “UDPHS Endpoint Status Register (Control, Bulk, Interrupt Endpoints)”
- Section 32.7.20 “UDPHS Endpoint Status Register (Isochronous Endpoint)”
Renamed ER_CRC_NTR bitfield to ERR_CRC_NTR.
Added ISOENDPT right-hand side qualifier to alternate register definitions in Section 32.7.10, Section 32.7.12,
Section 32.7.14, Section 32.7.16, Section 32.7.18, and Section 32.7.20. Fixed typos.
Section 32.2 “Embedded Characteristics”: removed Figure 32-1. USB Selection and Table 32-1. UDPHS
Endpoint Description (see Section 32.6.1 and Section 32.6.4 instead).
Added Section 32.6.1 “UTMI Transceivers Sharing” (extracted from Section 32.2 “Embedded Characteristics”).
Updated Section 32.6.4 “USB Transfer Event Definitions”: added Table 32-4 “UDPHS Endpoint Description” with
notes and the text below (extracted from
Section 32.2 “Embedded Characteristics”).
79
86
8396
84
05
rfo
UHPHS:
Section 33.2 “Embedded Characteristics”: removed Figure 33-1 USB Selection, Section 33.2.1 EHCI and Section
33.2.2 OHCI including Figure 33-2 Board Schematics to Interface UHP Device Controller.
Added Section 33.4 “Typical Connection” and Section 33.6 “Functional Description” (extracted from Section 33.2
“Embedded Characteristics”).
Section 33.4 “Typical Connection”, replaced the typical connection figure with a new Figure 33-2 “Board
Schematic to Interface UHP High-speed Host Controller”.
8104,
8236
Doc. Rev.
11032B
Comments Change
Request
Ref.