Datasheet

483
SAM7X Series [DATASHEET]
6120K–ATARM–11-Feb-14
36.3 Application Block Diagram
Figure 36-2. Application Block Diagram
36.4 I/O Lines Description
36.5 Product Dependencies
36.5.1 I/O Lines
The pins used for interfacing the CAN may be multiplexed with the PIO lines. The programmer must first program the PIO
controller to assign the desired CAN pins to their peripheral function. If I/O lines of the CAN are not used by the
application, they can be used for other purposes by the PIO Controller.
36.5.2 Power Management
The programmer must first enable the CAN clock in the Power Management Controller (PMC) before using the CAN.
A Low-power Mode is defined for the CAN controller: If the application does not require CAN operations, the CAN clock
can be stopped when not needed and be restarted later. Before stopping the clock, the CAN Controller must be in Low-
power Mode to complete the current transfer. After restarting the clock, the application must disable the Low-power Mode
of the CAN controller.
36.5.3 Interrupt
The CAN interrupt line is connected on one of the internal sources of the Advanced Interrupt Controller. Using the CAN
interrupt requires the AIC to be programmed first. Note that it is not recommended to use the CAN interrupt line in edge-
sensitive mode.
Software
Software
CAN Controller
Transceiver
ImplementationLayers
CAN-based Application Layer
CAN-based Profiles
CAN Data Link Layer
CAN Physical Layer
Table 36-1. I/O Lines Description
Name Description Type
CANRX CAN Receive Serial Data Input
CANTX CAN Transmit Serial Data Output