Datasheet

429
SAM7X Series [DATASHEET]
6120K–ATARM–11-Feb-14
34. USB Device Port (UDP)
34.1 Overview
The USB Device Port (UDP) is compliant with the Universal Serial Bus (USB) V2.0 full-speed device specification.
Each endpoint can be configured in one of several USB transfer types. It can be associated with one or two banks of a
dual-port RAM used to store the current data payload. If two banks are used, one DPR bank is read or written by the
processor, while the other is read or written by the USB device peripheral. This feature is mandatory for isochronous
endpoints. Thus the device maintains the maximum bandwidth (1M bytes/s) by working with endpoints with two banks of
DPR.
Note: 1. The Dual-Bank function provides two banks for an endpoint. This feature is used for ping-pong mode.
Suspend and resume are automatically detected by the USB device, which notifies the processor by raising an interrupt.
Depending on the product, an external signal can be used to send a wake up to the USB host controller.
34.2 Block Diagram
Figure 34-1. Block Diagram
Table 34-1. USB Endpoint Description
Endpoint Number Mnemonic Dual-Bank
(1)
Max. Endpoint Size Endpoint Type
0 EP0 No 8 Control/Bulk/Interrupt
1 EP1 Yes 64 Bulk/Iso/Interrupt
2 EP2 Yes 64 Bulk/Iso/Interrupt
3 EP3 No 64 Control/Bulk/Interrupt
4 EP4 Yes 256 Bulk/Iso/Interrupt
5 EP5 Yes 256 Bulk/Iso/Interrupt
Atmel Bridge
12 MHz
Suspend/Resume Logic
W
r
a
p
p
e
r
W
r
a
p
p
e
r
U
s
e
r
I
n
t
e
r
f
a
c
e
Serial
Interface
Engine
SIE
MCK
Master Clock
Domain
Dual
Port
RAM
FIFO
UDPCK
Recovered 12 MHz
Domain
udp_int
USB Device
Embedded
USB
Transceiver
DP
DM
external_resume
APB
to
MCU
Bus
txoen
eopn
txd
rxdm
rxd
rxdp