Datasheet

37
SAM7S Series [DATASHEET]
6175KS–ATARM–25-Oct-12
10.5 Serial Peripheral Interface
z Supports communication with external serial devices
z Four chip selects with external decoder allow communication with up to 15 peripherals
z Serial memories, such as DataFlash
®
and 3-wire EEPROMs
z Serial peripherals, such as ADCs, DACs, LCD Controllers, CAN Controllers and Sensors
z External co-processors
z Master or slave serial peripheral bus interface
z 8- to 16-bit programmable data length per chip select
z Programmable phase and polarity per chip select
z Programmable transfer delays between consecutive transfers and between clock and data per chip select
z Programmable delay between consecutive transfers
z Selectable mode fault detection
z Maximum frequency at up to Master Clock
10.6 Two-wire Interface
z Master Mode only (SAM7S512/256/128/64/321/32)
z Master, Multi-Master and Slave Mode support (SAM7S161/16)
z General Call supported in Slave Mode (SAM7S161/16)
z Compatibility with I
2
C compatible devices (refer to the TWI sections of the datasheet)
z One, two or three bytes internal address registers for easy Serial Memory access
z 7-bit or 10-bit slave addressing
z Sequential read/write operations
10.7 USART
z Programmable Baud Rate Generator
z 5- to 9-bit full-duplex synchronous or asynchronous serial communications
z 1, 1.5 or 2 stop bits in Asynchronous Mode
z 1 or 2 stop bits in Synchronous Mode
z Parity generation and error detection
z Framing error detection, overrun error detection
z MSB or LSB first
z Optional break generation and detection
z By 8 or by 16 over-sampling receiver frequency
z Hardware handshaking RTS - CTS
z Modem Signals Management DTR-DSR-DCD-RI on USART1 (not present on SAM7S32/16)
z Receiver time-out and transmitter timeguard
z Multi-drop Mode with address generation and detection
z RS485 with driver control signal
z ISO7816, T = 0 or T = 1 Protocols for interfacing with smart cards
z NACK handling, error counter with repetition and iteration limit
z IrDA modulation and demodulation
z Communication at up to 115.2 Kbps
z Test Modes
z Remote Loopback, Local Loopback, Automatic Echo