Manualshelf

Datasheet

ManualsBrandsMICROCHIP TECHNOLOGY ManualsMicrocontrollers, Microprocessors & QuartzesEmbedded microcontroller QFN 48 (7x7) 16/32-Bit 55 MHz I/O number 21
411412413414415416417418419420
Table Of Contents
414
SAM7S Series [DATASHEET]
6175M–ATARM–26-Oct-12
32.6.1.4 Serial Clock Ratio Considerations
The Transmitter and the Receiver can be programmed to operate with the clock signals provided on either the TK
or RK pins. This allows the SSC to support many slave-mode data transfers. In this case, the maximum clock
speed allowed on the RK pin is:
– Master Clock divided by 2 if Receiver Frame Synchro is input
– Master Clock divided by 3 if Receiver Frame Synchro is output
In addition, the maximum clock speed allowed on the TK pin is:
– Master Clock divided by 6 if Transmit Frame Synchro is input
– Master Clock divided by 2 if Transmit Frame Synchro is output
32.6.2 Transmitter Operations
A transmitted frame is triggered by a start event and can be followed by synchronization data before data
transmission.
The start event is configured by setting the Transmit Clock Mode Register (SSC_TCMR). See “Start” on page 415.
The frame synchronization is configured setting the Transmit Frame Mode Register (SSC_TFMR). See “Frame
Sync” on page 417.
To transmit data, the transmitter uses a shift register clocked by the transmitter clock signal and the start mode
selected in the SSC_TCMR. Data is written by the application to the SSC_THR register then transferred to the shift
register according to the data format selected.
When both the SSC_THR and the transmit shift register are empty, the status flag TXEMPTY is set in SSC_SR.
When the Transmit Holding register is transferred in the Transmit shift register, the status flag TXRDY is set in
SSC_SR and additional data can be loaded in the holding register.
Figure 32-8. Transmitter Block Diagram
32.6.3 Receiver Operations
A received frame is triggered by a start event and can be followed by synchronization data before data
transmission.
The start event is configured setting the Receive Clock Mode Register (SSC_RCMR). See “Start” on page 415.
Transmit Shift Register
Start
Selector
SSC_TSHRSSC_THR
Transmitter Clock
TD
SSC_TFMR.FSLENSSC_TFMR.DATLEN
SSC_CR.TXEN
SSC_CR.TXDIS
SSC_TCMR.STTDLY
SSC_TFMR.FSDEN
SSC_TFMR.DATNB
SSC_SR.TXEN
SSC_TFMR.DATDEF
SSC_TFMR.MSBF
SSC_TCMR.STTDLY
SSC_TFMR.FSDEN
0
1
10
RF
TF