Datasheet

447
6120F–ATARM–03-Oct-06
AT91SAM7X512/256/128 Preliminary
34.5.2.7 Using Endpoints With Ping-pong Attributes
During isochronous transfer, using an endpoint with ping-pong attributes is obligatory. To be
able to guarantee a constant bandwidth, the microcontroller must read the previous data pay-
load sent by the host, while the current data payload is received by the USB device. Thus two
banks of memory are used. While one is available for the microcontroller, the other one is locked
by the USB device.
Figure 34-10. Bank Swapping in Data OUT Transfers for Ping-pong Endpoints
When using a ping-pong endpoint, the following procedures are required to perform Data OUT
transactions:
1. The host generates a Data OUT packet.
2. This packet is received by the USB device endpoint. It is written in the endpoint’s FIFO
Bank 0.
3. The USB device sends an ACK PID packet to the host. The host can immediately send
a second Data OUT packet. It is accepted by the device and copied to FIFO Bank 1.
4. The microcontroller is notified that the USB device has received a data payload, polling
RX_DATA_BK0 in the endpoint’s UDP_ CSRx register. An interrupt is pending for this
endpoint while RX_DATA_BK0 is set.
5. The number of bytes available in the FIFO is made available by reading RXBYTECNT
in the endpoint’s UDP_ CSRx register.
6. The microcontroller transfers out data received from the endpoint’s memory to the
microcontroller’s memory. Data received is made available by reading the endpoint’s
UDP_ FDRx register.
7. The microcontroller notifies the USB peripheral device that it has finished the transfer
by clearing RX_DATA_BK0 in the endpoint’s UDP_ CSRx register.
8. A third Data OUT packet can be accepted by the USB peripheral device and copied in
the FIFO Bank 0.
9. If a second Data OUT packet has been received, the microcontroller is notified by the
flag RX_DATA_BK1 set in the endpoint’s UDP_ CSRx register. An interrupt is pending
for this endpoint while RX_DATA_BK1 is set.
USB Device USB Bus
Read
Write
Write and Read at the Same Time
1
st
Data Payload
2
nd
Data Payload
3
rd
Data Payload
3
rd
Data Payload
2
nd
Data Payload
1
st
Data Payload
Data IN Packet
Data IN Packet
Data IN Packet
Microcontroller
Endpoint 1
Bank 0
Endpoint 1
Bank 1
Endpoint 1
Bank 0
Endpoint 1
Bank 0
Endpoint 1
Bank 0
Endpoint 1
Bank 1