Datasheet

352
6120F–ATARM–03-Oct-06
AT91SAM7X512/256/128 Preliminary
31.6.5 Frame Sync
The Transmitter and Receiver Frame Sync pins, TF and RF, can be programmed to generate
different kinds of frame synchronization signals. The Frame Sync Output Selection (FSOS)
field in the Receive Frame Mode Register (SSC_RFMR) and in the Transmit Frame Mode
Register (SSC_TFMR) are used to select the required waveform.
• Programmable low or high levels during data transfer are supported.
• Programmable high levels before the start of data transfers or toggling are also supported.
If a pulse waveform is selected, the Frame Sync Length (FSLEN) field in SSC_RFMR and
SSC_TFMR programs the length of the pulse, from 1 bit time up to 16 bit time.
The periodicity of the Receive and Transmit Frame Sync pulse output can be programmed
through the Period Divider Selection (PERIOD) field in SSC_RCMR and SSC_TCMR.
31.6.5.1 Frame Sync Data
Frame Sync Data transmits or receives a specific tag during the Frame Sync signal.
During the Frame Sync signal, the Receiver can sample the RD line and store the data in the
Receive Sync Holding Register and the transmitter can transfer Transmit Sync Holding Regis-
ter in the Shifter Register. The data length to be sampled/shifted out during the Frame Sync
signal is programmed by the FSLEN field in SSC_RFMR/SSC_TFMR.
Concerning the Receive Frame Sync Data operation, if the Frame Sync Length is equal to or
lower than the delay between the start event and the actual data reception, the data sampling
operation is performed in the Receive Sync Holding Register through the Receive Shift
Register.
The Transmit Frame Sync Operation is performed by the transmitter only if the bit Frame Sync
Data Enable (FSDEN) in SSC_TFMR is set. If the Frame Sync length is equal to or lower than
the delay between the start event and the actual data transmission, the normal transmission
has priority and the data contained in the Transmit Sync Holding Register is transferred in the
Transmit Register, then shifted out.
31.6.5.2 Frame Sync Edge Detection
The Frame Sync Edge detection is programmed by the FSEDGE field in
SSC_RFMR/SSC_TFMR. This sets the corresponding flags RXSYN/TXSYN in the SSC Sta-
tus Register (SSC_SR) on frame synchro edge detection (signals RF/TF).
31.6.6 Receive Compare Modes
Figure 31-12. Receive Compare Modes
CMP0
CMP3
CMP2
CMP1
Ignored
B0
B2
B1
Start
RK
RD
(Input)
FSLEN
Up to 16 Bits
(4 in This Example)
STDLY DATLEN