Datasheet
26
AT90PWM216/316 [DATASHEET]
7710HS–AVR–07/2013
9.3 Rev. 7710F – 09/11
9.4 Rev. 7710E – 08/10
9.5 Rev. 7710D
1. Updated table page 2.
2. Updated “Absolute Maximum Ratings*” on page 283
22. Updated “Analog Comparator Status Register – ACSR” on page 219. Added Bit 3 - CLKPLL
23. Updated “Amplifier” on page 239. The correct content: “The ADC starting is done by setting the ADSC (ADC Start
conversion) bit in the ADCSRA register”.
24. Updated Figure 20-15 on page 240 and Figure 20-16 on page 241. Changed CKADC to CKADC2.
25. Updated “PSC Output Behavior During Reset” on page 266. If PSCRV fuse equals 0 (programmed), the selected
PSC outputs will be forced to high state. If PSCRV fuse equals 1 (unprogrammed), the selected PSC outputs will be
forced to low state.
26. Updated “Electrical Characteristics” on page 283. Added “DAC Characteristics” on page 290.
27. Updated the Table 25-1 on page 285. Replaced -40C - 85C with -40C to 105C
28. Updated Table 25-5 on page 289. Replaced V
INT
parameter by A
REF
. Min and Max values updated.
1. Updated Table 8-1 on page 41. Added V
POR
and V
CCR
in the table.
2. Updated Table 8-2 on page 42. Added min and max values for 101 and 010.
3. Updated Table 25-2 on page 286. V
CC
= 1.8 - 5.5V columns removed.
1. Updated “Port C (PC7..PC0)” on page 9.
2. Inserted a footnote “AT90PWM216 device is available in SOIC 24-pin Package and does not
have the D2A (DAC Output) brought out to I/0 pins.” on page 9.
3. Updated “Idle Mode” on page 35 by removing the reference to ACD.
4. Updated “Voltage Reference Enable Signals and Start-up Time” on page 44. Removed
reference to ACBG.
4. Updated Table 15-14 on page 157; Table 15-15 on page 158 and Table 15-16 on page 159
5. Removed reference to the ACCKDIV from “Analog Comparator” on page 215 and from “Register
Summary” on page 11.
6. Updated “ADC Prescaler Selection” on page 237.
7. Updated Table 25-5 on page 289 with Max and Min value for Internal Voltage Reference
8. Removed AC2SADE bit from “Register Summary” on page 11.