Datasheet

316
7734Q–AVR–02/12
AT90PWM81/161
5. Remove chapter 16.3 Band Gap calibration procedure on Page 191.
6. Update Temperature calibration on Page 191.
7. Remove chapter 16.4.3 Two Points Temperature sensor calibration on Page 197.
8. Update Signature Row Addressing on Page249.
9. Update DC Characteristics:
Update table 23-1 Page 275: RC calibartion @25°C
Update Table 23.2 page 272: -40°C in place of -45°C
New Table in 23.2: -40°C to +125°C
10. Update Erratasheet.
28.10 Rev. 7734J
1. Page 2 Table 2-1: QFN32 : 32 Pins.
2. Page 6 Table 3-2: SO24 and QFN20 are removed.
3. Page 30 section 6.2.2.1: RC Osc. is monitored @125°C.
4. Page 51: Table 8.2: BODenable is mandatory.
5. Page 166: removed AT90PWM2/3 comments.
6. Page 267 Table 23-1: User Calibration at +5%.
7. Page 271: Update of ADC Characteristics.
8. Page 273: Add the DAC Characteristics.
28.11 Rev. 7734K
1. Page 193 §16.4.1: removed the last sentence about reading of the temperature sensor during
Hot testing.
2. Page 193 §16.4.1: T formula modifed with new TSGAIN.
3. Page 244 Table 21.5: Signature row adressing table updated with right address.
28.12 Rev. 7734L
1. Update Errata Rev E.
28.13 Rev. 7734M
1. Page 204: Figure 18-1 removed REFS2 bit.
2. .Pages 277 to 294: update of Typical characteristics.
28.14 Rev. 7734N
1. Page 52: update of BOD levels.
2. Pages 267, 268, 269, 270: update of Vref, Icc power-down, Icc operating, Icc Idle and
Watchdog oscillator characteristics.
28.15 Rev. 7734O
1. Pages 275, 276 Table 23-6: update of ADC characteristics.
2. Page 270: add a new line in Table 23-1 (Calibrated Internal RC oscillator Accuracy).
3. Pages 267, 269, 279: update of Analog comparator characteristics.