Datasheet

554
32072H–AVR32–10/2012
AT32UC3A3
Interrupt Mask Register (IMR.RXRDY) is set. If CSR.RXRDY is already set, RHR will be over-
written and the Overrun Error bit (CSR.OVRE) is set. An interrupt request is generated if the
Overrun Error bit in IMR is set. Reading RHR will clear CSR.RXRDY, and writing a one to the
Reset Status bit in the Control Register (CR.RSTSTA) will clear CSR.OVRE. Refer to Figure 25-
7.
25.6.3 Other Considerations
25.6.3.1 Parity
The USART supports five parity modes, selected by MR.PAR:
• Even parity
•Odd parity
• Parity forced to zero (space)
• Parity forced to one (mark)
• No parity
The PAR field also enables the Multidrop mode, see ”Multidrop Mode” on page 555. If even par-
ity is selected (MR.PAR is 0x0), the parity bit will be zero if there is an even number of ones in
the data character, and one if there is an odd number. For odd parity the reverse applies. If
space or mark parity is chosen (MR.PAR is 0x2 or 0x3, respectively), the parity bit will always be
a zero or one, respectively. See Table 25-4.
The receiver will report parity errors in CSR.PARE, unless parity is disabled. An interrupt request
is generated if the PARE bit in the Interrupt Mask Register is set (IMR.PARE). Writing a one to
CR.RSTSTA will clear CSR.PARE. See Figure 25-8.
Figure 25-8. Parity Error
Table 25-4. Parity Bit Examples
Alphanum
Character Hex Bin
Parity Mode
Odd Even Mark Space None
A 0x41 0100 0001 1 0 1 0 -
V 0x56 0101 0110 1 0 1 0 -
R 0x52 0101 0010 0 1 1 0 -
D0 D1 D2 D3 D4 D5 D6 D7
RXD
Start
Bit
Bad
Parity
Bit
Stop
Bit
Baud Rate
Clock
Write
CR
PARE
RXRDY
RSTSTA = 1