User manual

Atmel AVR32918: UC3-A3 Xplained Hardware User’s Guide [APPLICATION NOTE]
32159C−AVR−07/2012
3
1. Related items
Atmel Xplained products
Xplained is a series of small-sized and easy-to-use evaluation kits for 8- and 32-bit AVR microcontrollers. It consists of
a series of low cost MCU boards for evaluation and demonstration of feature and capabilities of different MCU families.
Atmel Studio
®
Atmel Studio is a free IDE for development of C/C++ and assembler code for Atmel microcontrollers.
Atmel FLIP (Flexible In-system Programmer)
BatchISP (FLIP) is a command line tool for programming the flash and EEPROM memories of the AVR and is part of
the FLIP installation. It can be used to communicate with the preprogrammed USB DFU boot loader.
Atmel JTAGICE 3
JTAGICE 3 is a mid-range development tool for Atmel 8- and 32-bit AVR microcontrollers with on-chip debugging for
source level symbolic debugging, NanoTrace (if supported by the device) and device programming.
Atmel AVR ONE!
AVR ONE! is a professional development tool for all Atmel 8- and 32-bit AVR devices with on-chip debug capability. It is
used for source level symbolic debugging, program trace, and device programming. The AVR ONE! supports the
complete development cycle and is the fastest debugging tool offered from Atmel.
Atmel Software Framework (ASF)
The Atmel® Software Framework (ASF) is a collection of embedded software for Atmel flash MCU.
Atmel AVR32930: UC3-A3 Xplained Getting Started Guide
Atmel AVR32930: UC3-A3 Xplained Getting Started Guide source code
UC3-A3 Xplained design documentation (schematics, BOM …)
2. General information
The Atmel UC3-A3 Xplained kit is intended to demonstrate the Atmel AT32UC3A3256 microcontroller. Figure 2-1 shows
the available feature on the board.
Figure 2-1. Overview of the UC3-A3 Xplained kit.