User manual

LIN Serial Analyzer User’s Guide Rev2.0

3.5.3 Slave Response

The Slave Response setup function specifies message frames that are published to the

bus whenever the correct ID is recognized.

FIGURE 3-6: SLAVE RESPONSE SETUP WINDOW

To display the dialog box, select Setup>Slave Response

3.5.4 Slave Response Frames Field

The “Slave Response Frames” field is composed of 0 to n rows of one or more mes-

sages that are sent over the bus in response to a valid ID byte. These messages can

be entered manually, loaded from a previously saved session, or both.

When the response is sent, it is displayed in the Transaction window if it is open and

active.

Messages in the “Slave Response Frames” field can also be saved for reuse (see

Section 3.4.2 “Save” and Section 3.4.3 “Save As”).

3.5.4.1 RESPONSE SYNTAX

Messages must consist of the ID byte without parity bits and the data bytes, all

separated by spaces. All inputs are in hexadecimal radix.

The checksum is not included; it is calculated at send time unless the “forced” Check-

sum option is selected.

Comments or notes may be attached to each frame by prefacing it with a

semi-colon (;). Any text after the semi-colon will be disregarded and not transmitted. All

notes will be saved in the selected .ini file and reloaded when reopened.