User manual

MCP16301 300 mA D

PAK

DEMO BOARD USER’S GUIDE

Preface

INTRODUCTION

This chapter contains general information that will be useful to know before using the

MCP16301 300 mA D

PAK Demo Board. Items discussed in this chapter include:

• Document Layout

• Conventions Used in this Guide

• Recommended Reading

• The Microchip Web Site

• Customer Support

• Document Revision History

DOCUMENT LAYOUT

This document describes how to use the MCP16301 300 mA D

PAK Demo Board as

a development tool to emulate and debug firmware on a target board. The manual

layout is as follows:

• Chapter 1. “Product Overview” – Important information about the MCP16301

300 mA D

PAK Demo Board.

• Chapter 2. “Installation and Operation” – Includes instructions on how to get

started with MCP16301 300 mA D

PAK Demo Board and a description of the

user’s guide.

• Appendix A. “Schematics and Layouts” – Shows the schematic and layout

diagrams for the MCP16301 300 mA D

PAK Demo Board.

• Appendix B. “Bill of Materials (BOM)” – Lists the parts used to build the

MCP16301 300 mA D

PAK Demo Board.

NOTICE TO CUSTOMERS

All documentation becomes dated, and this manual is no exception. Microchip tools and

documentation are constantly evolving to meet customer needs, so some actual dialogs

and/or tool descriptions may differ from those in this document. Please refer to our web site

(www.microchip.com) to obtain the latest documentation available.

Documents are identified with a “DS” number. This number is located on the bottom of each

page, in front of the page number. The numbering convention for the DS number is

“DSXXXXXA”, where “XXXXX” is the document number and “A” is the revision level of the

document.

For the most up-to-date information on development tools, see the MPLAB

IDE on-line help.

Select the Help menu, and then Topics to open a list of available on-line help files.