User manual

MCP3903 ADC EVALUATION BOARD

FOR 16-BIT MCUs USER’S GUIDE

Preface

INTRODUCTION

This chapter contains general information that will be useful to know before using the

MCP3903 ADC Evaluation Board for 16-Bit MCUs. Items discussed in this chapter

include:

• Document Layout

• Conventions Used in this Guide

• Recommended Reading

• The Microchip Web Site

• Customer Support

• Document Revision History

DOCUMENT LAYOUT

This document describes how to use the MCP3903 ADC Evaluation Board for 16-Bit

MCUs as a development tool to emulate and debug firmware on a target board. The

manual layout is as follows:

• Chapter 1. “Hardware Description”– Provides important information about the

hardware.

• Chapter 2. “Code example”– Describes the firmware.

• Appendix A. “Schematics and Layouts”– Shows the schematic and board

layouts.

• Appendix B. “Bill of Materials (BOM)” – Lists the parts used to build the

MCP3903 ADC Evaluation Board for 16-Bit MCUs.

NOTICE TO CUSTOMERS

All documentation becomes dated, and this manual is no exception. Microchip tools and

documentation are constantly evolving to meet customer needs, so some actual dialogs

and/or tool descriptions may differ from those in this document. Please refer to our web site

(www.microchip.com) to obtain the latest documentation available.

Documents are identified with a “DS” number. This number is located on the bottom of each

page, in front of the page number. The numbering convention for the DS number is

“DSXXXXXA”, where “XXXXX” is the document number and “A” is the revision level of the

document.

For the most up-to-date information on development tools, see the MPLAB

IDE on-line help.

Select the Help menu, and then Topics to open a list of available on-line help files.