User manual

EEP and Emulation Header Overview
 2014 Microchip Technology Inc. DS50002243A-page 9
FIGURE 1-4: MPLAB
®
REAL ICE™ IN-CIRCUIT EMULATOR
CONNECTIONS
4. Connect the header to the target board. On the bottom of the header is a socket
that is used to connect to the target board. The header can be connected to the
target board as follows:
a) PDIP header socket to PDIP target socket with a stand-off (male-to-male)
connector or single in-line pins
b) Header socket to plug on the target board
c) Header socket to target socket with a transition socket (see the “Transition
Socket Specification”, DS51194)
An example connection is shown in Figure 1-5.
The header socket will have the same pin count as your selected device. The
-ME2 device on the top of the header usually has a larger pin count because it
has additional pins that are dedicated to debug.
FIGURE 1-5: CONNECT HEADER TO TARGET
5. If using a debug tool that can power the target, power that tool now.
6. Power the target, if needed.
Power In
Target Board (Top)
Target Socket
Stand-off Connector
Emulation Header (Bottom)
Header Socket