User manual

EEP and Emulation Header User’s Guide
DS50002243A-page 8  2014 Microchip Technology Inc.
1.4 GENERAL EMULATION HEADER SETUP
To set up your header, follow these instructions, before doing anything else:
1. Check the header box for any paper inserts that specify special operating instruc-
tions and the emulation header for any stickers (Figure 1-1).
FIGURE 1-1: SPECIAL HEADER INSTRUCTIONS
2. Set any jumpers or switches on the header to determine device functionality or
selection as specified for that header. See the section “Emulation Header List”
for information on how to set up individual headers.
3. Connect the header to your desired debug tool by consulting the tool
documentation for connection options. Example connections are shown in
Figures 1-2 through 1-4.
FIGURE 1-2: PICkit 3™ IN-CIRCUIT DEBUGGER CONNECTIONS
FIGURE 1-3: MPLAB ICD
®
3 IN-CIRCUIT DEBUGGER CONNECTIONS
Emulation Header (Top)
CAUTION
C
A
U
T
I
O
N