User manual

Emulation Header List
 2014 Microchip Technology Inc. DS50002243A-page 33
3.4.4 Header Dimensions
The figure below lists the dimensions for the emulation header. Dimensions are design
values in inches.
If the length and/or width of the emulation header is too large a footprint for the target
board, consider using stand-offs, single in-line pins, transition sockets or other
extenders in the header connection socket to raise the header above the target.
FIGURE 3-3: DIMENSIONS - AC244064
44-Pin TQFP Target Pin 1 located
on Bottom side of Header
Dimensions are in inches
40-Pin DIP Target Pin 1 located
on Bottom side of Header
28-Pin DIP Target Pin 1 located
on Bottom side of Header
44-Pin QFP Target Pin 1 located
on Bottom side of Header
Trace
2.575
0.710
0.310
3.400
1.280
0.255
0.710
0.970
1.270
0.801
0.650
ME2
Device
Header
Cable
Top
Side
0.560 Typical
0.062 Typical
0.335 Typical
Optional 6-pin SIL
Connector (0.100 pin
spacing)
See Chapter 5.
“Emulation Header
Connections”.
6-pin Modular 
Connector
See Chapter 5.
“Emulation Header
Connections”.