User manual

Emulation Header List
 2014 Microchip Technology Inc. DS50002243A-page 31
3.3.4 Header Dimensions
The figure below lists the dimensions for the emulation header. Dimensions are design
values in inches.
If the length and/or width of the emulation header is too large a footprint for the target
board, consider using stand-offs, single in-line pins, transition sockets or other
extenders in the header connection socket to raise the header above the target.
FIGURE 3-2: DIMENSIONS - AC244063
Dimensions are in inches
20-Pin DIP Target Pin 1 located
on Bottom side of Header
18-Pin DIP Target Pin 1 located
on Bottom side of Header
Optional 6-pin SIL Connector
(0.100 pin spacing)
See Chapter 5. “Emulation
Header Connections”.
6-pin Modular 
Connector
See Chapter 5. “Emu-
lation Header Con-
nections”.
2.575
2.300
0.140
0.975
0.475
0.800
Trace
Header
Cable
Top
Side
0.560 Typical
0.165 Typical
0.062 Typical Board Thickness
ME2
Device