Datasheet

Messages
 2013 Microchip Technology Inc. DS52085A-page 93
The MPLAB REAL ICE is missing its Program Executive. Please reconnect to the
PC and try again.
The MPLAB REAL ICE is missing its Debug Executive. Please reconnect to the
PC and try again.
The MPLAB REAL ICE is missing its Device Database. Please reconnect to the
PC and try again.
The MPLAB REAL ICE is missing a Memory Object.
The current memory object in the MPLAB REAL ICE is corrupted. Please retry the
operation.
Unable to download debug executive
If you receive this error while attempting to debug:
1. Deselect the emulator as the debug tool.
2. Close you project and then close MPLAB IDE.
3. Restart MPLAB IDE and re-open your project.
4. Reselect the emulator as your debug tool and attempt to program your target
device again.
Unable to download program executive
If you receive this error while attempting to program:
1. Deselect the emulator as the programmer.
2. Close your project and then close MPLAB IDE.
3. Restart MPLAB IDE and re-open your project.
4. Reselect the emulator as your programmer and attempt to program your target
device again.
10.2.5 Debug Failure Errors
For the errors below, read any instructions under your error message. If these fail to fix
the problem or if there are no instructions, see Section 10.3.6 “Debug Failure
Actions”.
Unable to open debug executive file %s
The target device is not ready for debugging. Please check your configuration bit
settings and program the device before proceeding.
You will receive this message when you have not programmed your device for
the first time and try to Run. If you receive this message after this, or immediately
after programming your device, please refer to Section 10.3.6 “Debug Failure
Actions”.
An unknown exception has occurred. Please unplug the MPLAB REAL ICE and
reconnect.
The Target is held in Reset. Please ensure the MCLR line is pulled up or High-Z'd.
The Debug Executive is found but can't be communicated with. Please ensure
your oscillator settings are correct. If the device supports internal RC try to
connect via that mode first.
See also Section 10.3.2 “Emulator-to-Target Communication Error
Actions”.
REAL ICE was unloaded while still busy. Please unplug and reconnect the USB
cable before using REAL ICE again.
Target device was not found. You must connect to a target device to use MPLAB
REAL ICE.