Datasheet

Emulator User’s Guide for MPLAB X IDE
DS52085A-page 92  2013 Microchip Technology Inc.
10.2.2 Emulator-to-Target Communication Errors
For the errors below, read any instructions under your error message. If these fail to fix
the problem or if there are no instructions, see Section 10.3.2 “Emulator-to-Target
Communication Error Actions”.
Failed to reset the device
Failed while sending cmd_INITCOMM command
Failed while sending cmd_SETPROBES command
Failed while sending cmd_SETBRACKET
Failed to get status
Failed to send database
If you receive this error:
1. Try downloading again. It may be a one-time error.
2. Try manually downloading the highest-number .jam file.
Invalid command response (sent 0x%x, received 0x%x)
Failed while trying to enter ICE test mode
Failed while trying to start DMA test
Failed to properly receive DMA test data
Timed out while waiting to process data from endpoint 0x%x
transmission failure while receiveing streaming data
Interrupted Exception occurred %s
Unable to start streaming data reception
Unable to start run time data reception
Failed getting PC
10.2.3 Emulator-to-PC Communcation Errors
For the errors below, read any instructions under your error message. If these fail to fix
the problem or if there are no instructions, see Section 10.3.3 “Emulator-to-PC Com-
munication Error Actions”.
Failed to set debug options
Failed while stepping the target
Failed while halting the target
Cannot communicate with %s
10.2.4 Corrupted/Outdated Installation Errors
For the errors below, read any instructions under your error message. If these fail to fix
the problem or if there are no instructions, see Section 10.3.4 “Corrupted Installation
Actions”.
Failed to download firmware
If the Hex file exists:
- Reconnect and try again.
- If this does not work, the file may be corrupted. Reinstall MPLAB IDE.
If the Hex file does not exist:
- Reinstall MPLAB IDE.