Datasheet

MPLAB
®
REAL ICE
™
IN-CIRCUIT
EMULATOR USER’S GUIDE FOR
MPLAB X IDE
 2013 Microchip Technology Inc. DS52085A-page 91
Chapter 10. Messages
10.1 INTRODUCTION
The MPLAB REAL ICE in-circuit emulator produces many different output messages.
Some are error messages, many of which can often be resolved with general corrective
actions. And some are informational only.
• Error Messages
• General Corrective Actions
• Informational Messages
10.2 ERROR MESSAGES
MPLAB REAL ICE in-circuit emulator error messages are listed below. Text in error
messages listed below of the form %x (a variable) will display as text relevant to your
particular situation in the actual error message.
• Read/Write Errors
• Emulator-to-Target Communication Errors
• Emulator-to-PC Communcation Errors
• Corrupted/Outdated Installation Errors
• Debug Failure Errors
• Hardware/Firmware Errors
• Miscellaneous Errors
• Internal Errors
10.2.1 Read/Write Errors
For the errors below, read any instructions under your error message. If these fail to fix
the problem or if there are no instructions, see Section 10.3.1 “Read/Write Error
Actions”.
Failed while writing to %s
Failed while reading %s
Failed to program device
Failed to read device
Failed to write to %s memory
Failed to erase the device
Unable to read target register(s).
Unable to write target register(s).
Programming debug executive failed
Programming program executive failed
Failed to get Device ID