Datasheet

Emulator User’s Guide for MPLAB X IDE
DS52085A-page 90  2013 Microchip Technology Inc.
Q: I accidentally disconnected my emulator while firmware was downloading. What
do I do now?
A: Reconnect the emulator. It will begin to erase what had been written so it can
restart. This erasing will take about 75 seconds (1:15 mins). Please be patient.
You will see:
- the orange busy light turn on for about 25 seconds
- the light turn red for about another 25 seconds
- the light turn orange again for about another 25 seconds
When it turns back to red again, MPLAB IDE will recognize the device and start
the recovery process, i.e., begin firmware download.
Q: My memory window does not reflect changes
A: In order to see changes in the window, you must do a read of the memory.
Q: I don’t see my problem here. Now what?
A: Try the following resources:
Section 3.10 “Resources Used by the Emulator”
Section 10.2 “Error Messages”
Section 10.3 “General Corrective Actions”