Datasheet

Device and Feature Support
 2013 Microchip Technology Inc. DS52085A-page 21
2.2 16-BIT (DATA MEMORY) DEVICES
The following table shows feature support for dsPIC30F/33F DSCs and PIC24F/H
MCUs.
Feature Tools
dsPIC33EP,
PIC24EP
dsPIC33F,
PIC24H
PIC24F
dsPIC30F
SMPS(3)
dsPIC30F
Reset application All C C C C C
Run, Halt All C C C C C
Single Step All C C C C C
Full Speed Emulation All C C C C C
Hardware Breakpoints All C C C C C
Advanced Breakpoints RI, ICD3 C C C C C
Software Breakpoints RI, ICD3 C C C C C
Peripheral Freeze
(1)
All C C C C C
Break on data fetch or write All C C C C C
Break on Stack overflow All N N F F N
Stopwatch All C C C C N
Pass Counter All C C C C C
WDT overflow All C C C C N
Native Trace - built-in
(2)
RI C C C C N
SPI Trace RI F C C D
(4)
D
(4)
I/O Port Trace RI F C C D
(5)
D
(5)
Trace Macros for C code RI C C C C C
Data Capture
(2)
RI C C C C N
Runtime Watch
(2)
RI C C C C N
Application Input/Output RI,ICD3 C N N N N
High Speed Comm. (LVDS) RI C C C C C
Processor Pak All F F D F N
External triggers (logic probes) RI C C C C C
MPLAB REAL ICE Isolator Unit RI C C C N N
Legend:
Tools = MPLAB REAL ICE in-circuit emulator (RI), MPLAB ICD 3 (IICD3), PICkit 3 (PK3), All 3 (All)
C = Current support (Green)
D = Support dependent on device (Yellow)
F = No support now, but planned in the future (Orange)
N = Support Not Available (Red)
Note 1: This feature operates differently depending on the selected device.
Note 2: At speeds higher than 15 MIPS, the Performance Pak may be needed.
Note 3: dsPIC30F Switch Mode Power Supply (SMPS) devices: dsPIC30F1010/2020/2023.
Note 4: No SPI Trace for devices with SPI port pins multiplexed with PGC/PGD pins.
Note 5: No I/O Port Trace for devices without a port with a full 8 bits available for trace OR devices with pin counts
of 44 or less.