Datasheet

Emulator User’s Guide for MPLAB X IDE
DS52085A-page 126  2013 Microchip Technology Inc.
FIGURE 13-15: JTAG ADAPTOR BOARD CONNECTIONS AND SET UP
13.5.3 Switch from JTAG to Standard Communications
To switch the hardware:
1. Device memory does not need to be erased in this case.
2. Power down the target board.
3. Disconnect the JTAB ribbon cable from the target, disconnect the USB cable
from the emulator, and unplug the JTAB adaptor board from the emulator.
4. Connect one end of the Standard Communications cable to the connector on the
Standard driver board and insert the board into the emulator driver board slot.
5. Connect the other end of the modular cable to the connector on a target board,
such as the Microchip Explorer 16 development board.
6. Connect the USB cable to the emulator and power the target board.
To set up MPLAB X IDE for Standard Communications operation:
1. Select File>Project Properties
. In the Project Properties dialog, click on your
desired configuration, e.g., “Conf: [default]”.
2. Click on the down arrow on the “Supported Plugin Board” dropdown box and
select “None”. Click OK to accept the setup.
13.5.4 Switch between High-Speed Communications and JTAG
Switching between High-Speed (LVDS) Communications and JTAG communications is
the same as switching between Standard Communications and JTAG communications.
Emulator Pod
Target Board
ACTIVE
STATUS
RESETFUNCTION
JTAG Adator Board
Ribbon Cable
JTAG
Target Board with
PIC32
JTAG connector
MPLAB
®
X IDE - Project Properties
Note: The target device DOES NOT NEED TO BE ERASED before switching
from JTAG communications to Standard Communications.