Datasheet

Hardware Specification
 2013 Microchip Technology Inc. DS52085A-page 113
12.5.2 Modular Cable and Connector
For standard communications, a modular cable connects the emulator and the target
application. The specifications for this cable and its connectors are listed below.
12.5.2.1 MODULAR CABLE SPECIFICATION
• Manufacturer, Part Number – Microchip Technology, 07-00024
The length for this cable (L) is 6 inches. If you require a longer cable, consider purchas-
ing the Performance Pak. For details see Section 13.3 “High-Speed/LVDS Commu-
nication Hardware (Performance Pak)”. It is not recommended that you use a
modular cable shorter than 6 inches or you may experience communication problems.
FIGURE 12-3: MODULAR CABLE
12.5.2.2 MODULAR PLUG SPECIFICATION
• Manufacturer, Part Number – AMP Incorporated, 5-554710-3
• Distributor, Part Number – Digikey, A9117ND
12.5.2.3 MODULAR CONNECTOR SPECIFICATION
• Manufacturer, Part Number – AMP Incorporated, 555165-1
• Distributor, Part Number – Digikey, A9031ND
The following table shows how the modular connector pins on an application
correspond to the microcontroller pins. This configuration provides full ICD
functionality.
FIGURE 12-4: MODULAR CONNECTOR PINOUT OF TARGET BOARD
Pin 1
L
Pin 6
Modular
Connector Pin
Microcontroller
Pin
6 Not Used
5 RB6
4RB7
3 Ground
2V
DD Targ et
1 VPP
1
6
Bottom view of Modular Connector
Pinout on Target Board
16
Front view of Modular Connector
on Target Board
35
42