Datasheet

Emulator User’s Guide for MPLAB X IDE
DS52085A-page 106  2013 Microchip Technology Inc.
11.3.8 Memories to Program
Select the memories to be programmed into the target.
TABLE 11-9: MEMORIES TO PROGRAM OPTION CATEGORY
Auto select memories and ranges Allow REAL ICE to Select Memories - The emula-
tor uses your selected device and default settings to
determine what to program.
Manually select memories and ranges - You select
the type and range of memory to program (see
below.)
Memory Check to program Memory, where Memory is the
type of memory. Types include: EEPROM, ID, Boot
Flash, Auxilliary.
Program Memory Check to program the target program memory range
specified below.
Program Memory Start (hex)
Program Memory End (hex)
The starting and ending hex address range in pro-
gram memory for programming, reading, or verifica-
tion.
If you receive a programming error due to an incor-
rect end address, correct the end address and pro-
gram again.
Note: The address range does not apply to the
Erase function. The Erase function will erase all data
on the device.
Preserve Program Memory Check to not program the target program memory
range specified below.
Preserve Program Memory Start (hex)
Preserve Program Memory End (hex)
The starting and ending hex address range in target
program memory to preserve when programming,
reading, or verifying.
This memory is read from the target and overlayed
with existing MPLAB X IDE memory.
Preserve Memory Check to not erase Memory when programming,
where Memory is the type of memory. Types include:
EEPROM, ID, Boot Flash, Auxilliary.