User manual

Error Messages

RIErr0061: Loopback VDD not detected. Please ensure your RJ-11 cable is

connected between the loopback board and the driver board. Unplug the REAL

ICE to try again.

Try the following:

1. Connect the cable between the loopback board and the Standard driver board.

2. Unplug and then plug in the emulator.

If this does not work, try a different cable and repeat the above steps.

RIErr0062: Loopback VPP failure.

Emulator power supply failure. Contact Microchip technical support.

RIErr0063: Loopback clock write failure.

RIErr0064: Loopback data write failure.

RIErr0065: Loopback clock read failure.

RIErr0066: Loopback data read failure.

Clock/data not being output from the emulator. Check your connections and try again.

RIErr0067: Failed to set/clear software breakpoint.

Reprogram and try again.

RIErr0068: Failed while writing to boot FLASH memory.

RIErr0069: Failed while reading boot FLASH memory.

RIErr0070: Failed while writing peripheral memory.

RIErr0071: Failed while reading peripheral memory.

See Section 10.3.1 “Read/Write Error Actions”.

RIErr0072: Unable to send freeze peripheral information.

See Section 10.3.3 “Emulator-to-PC Communication Error Actions”.

RIErr0073: Device is code protected.

The device on which you are attempting to operate (read, program, blank check or

verify) is code protected, i.e., the code cannot be read or modified. Check your

Configuration bits setting for code protection.

To disable code protection, set or clear the appropriate Configuration bits in code or in

the Configuration Bits window (Configure>Configuration Bits

), according to the device

data sheet. Then erase and reprogram the entire device.

RIErr0080: Failed setting shadow bit(s).

A file register read or write failed. See Section 10.3.2 “Emulator-to-Target

Communication Error Actions”.

10.3 GENERAL CORRECTIVE ACTIONS

These general corrective actions may solve your problem:

• Read/Write Error Actions

• Emulator-to-Target Communication Error Actions

• Emulator-to-PC Communication Error Actions

• Corrupted Installation Actions

• USB Port Communication Error Actions

• Debug Failure Actions

• Internal Error Actions