User manual

Error Messages

RIErr0030: Unable to read/find firmware File %s.

If the Hex file exists:

• Reconnect and try again.

• If this does not work, the file may be corrupted. Reinstall MPLAB IDE.

If the Hex file does not exist:

• Reinstall MPLAB IDE.

RIErr0031: Failed to get PC.

RIErr0032: Failed to set PC.

See Section 10.3.2 “Emulator-to-Target Communication Error Actions”.

RIErr0033: %d bytes expected, %d bytes received.

See Section 10.3.3 “Emulator-to-PC Communication Error Actions”.

RIErr0034: This version of MPLAB IDE does not support hardware revision %06x.

Please upgrade to the latest version of MPLAB IDE before continuing.

Find the latest MPLAB IDE at www.microchip.com.

RIErr0035: Failed to get Device ID.

See Section 10.3.1 “Read/Write Error Actions”.

RIErr0036: MPLAB IDE has lost communication with REAL ICE.

See Section 10.3.3 “Emulator-to-PC Communication Error Actions”.

RIErr0037: Timed out waiting for response from REAL ICE.

RIErr0038: Failed to intialize REAL ICE.

RIErr0039: REAL ICE self test failed.

For this error, the emulator is not responding:

1. Unplug and plug in the emulator.

2. Reconnect to the emulator in MPLAB IDE.

3. If the problem persists contact Microchip.

RIErr0040: The target device is not ready for debugging. Please check your

Configuration bit settings and program the device before proceeding.

You will receive this message when you have not programmed your device for the first

time and try to Run. If you receive this message after this, or immediately after

programming your device, please refer to Section 10.3.6 “Debug Failure Actions”.

RIErr0041: While receiving streaming data, REAL ICE has gotten out of synch

with MPLAB IDE. To correct this you must reset the target device.

Data capture or Native trace has gotten out-of-sync with MPLAB IDE. First try to Halt,

Reset and then Run again. If this does not work:

1. Unplug and plug in the emulator.

2. Reconnect to the emulator in MPLAB IDE.

3. Check that the target speed is entered on the Clock tab of the Settings dialog.

4. Run again.

RIErr0045: You must connect to a target device to use MPLAB REAL ICE.

No power has been found.

1. Ensure V

DD and GND are connected between the emulator and target.

2. Ensure that the target is powered.

3. Ensure that the target power is sufficient to be detected by the emulator (see

Chapter 12. “Hardware Specification”.)