User manual

Glossary
© 2008 Microchip Technology Inc. DS51616B-page 135
PRO MATE II
No longer in Production. See the MPLAB PM3 device programmer.
A device programmer from Microchip. Programs most PICmicro microcontrollers as
well as most memory and K
EELOQ devices. Can be used with MPLAB IDE or
stand-alone.
Profile
For MPLAB SIM simulator, a summary listing of executed stimulus by register.
Program Counter
The location that contains the address of the instruction that is currently executing.
Program Memory
The memory area in a device where instructions are stored. Also, the memory in the
emulator or simulator containing the downloaded target application firmware.
Project
A project contains the files needed to build an application (source code, linker script
files, etc.) along with their associations to various build tools and build options.
Prototype System
A term referring to a user's target application, or target board.
PWM Signals
Pulse Width Modulation Signals. Certain PICmicro MCU devices have a PWM
peripheral.
Qualifier
An address or an address range used by the Pass Counter or as an event before
another operation in a complex trigger.
Radix
The number base, hex, or decimal, used in specifying an address.
RAM
Random Access Memory (Data Memory). Memory in which information can be
accessed in any order.
Raw Data
The binary representation of code or data associated with a section.
Read Only Memory
Memory hardware that allows fast access to permanently stored data but prevents
addition to or modification of the data.
Real Time
When an in-circuit emulator or debugger is released from the halt state, the processor
runs in Real Time mode and behaves exactly as the normal chip would behave. In Real
Time mode, the real time trace buffer of an emulator is enabled and constantly captures
all selected cycles, and all break logic is enabled. In an in-circuit emulator or debugger,
the processor executes in real time until a valid breakpoint causes a halt, or until the
user halts the execution.
In the simulator, real time simply means execution of the microcontroller instructions as
fast as they can be simulated by the host CPU.
Real-Time Watch
A Watch window where the variables change in real-time as the application is run. See
individual tool documentation to determine how to set up a real-time watch. Not all tools
support real-time watches.