User manual

Emulator Function Summary
© 2008 Microchip Technology Inc. DS51616B-page 107
11.4 PROGRAMMING FUNCTIONS
When you select the MPLAB REAL ICE in-circuit emulator from the Programmer menu,
program items will be added to the following MPLAB IDE functions:
• Programmer Menu
• Toolbars/Status Bar
11.4.1 Programmer Menu
Program
Program specified memory areas: program memory, Configuration bits, ID locations
and/or EEPROM data. See the Settings dialog for programming options.
Verify
Verify programming of specified memory areas: program memory, Configuration bits,
ID locations and/or EEPROM data.
Read
Read specified memory areas: program memory, Configuration bits, ID locations
and/or EEPROM data. See the Settings dialog for read options.
Blank Check All
Check to see that all device memory is erased/blank.
Erase Flash Device
Erase all Flash memory.
Settings
Open the Programmer dialog (see Section 11.5 “Settings Dialog”). Set up program
and firmware options.
11.4.2 Toolbars/Status Bar
When the MPLAB REAL ICE in-circuit emulator is selected as a programmer, these
toolbars are displayed in MPLAB IDE:
• Basic program toolbar (Blank Check All, Read, Program, Verify, Erase Flash
Device).
The selected programmer (MPLAB REAL ICE), as well as other programming
information, is displayed in the status bar on the bottom of the MPLAB IDE desktop.
Refer to the MPLAB IDE on-line help for information on the contents of the status bar.
I/O Port Select to use a device I/O port for
trace, and then select the port you
will be using from the pull-down
list.
Section 7.3.3.2 “I/O Port Trace”
SPI* Select to use device SPI pins for
trace, and then select the SPI port
you will be using from the
pull-down list.
Section 7.3.3.3 “SPI Trace”
Device Resources
Used
For the communications medium
chosen, a description of device
resources used is displayed.
Section 7.3.3 “Types of Trace”
* Set your clock speed for these types of trace (Debugger>Settings, Clock tab.)
TABLE 11-7: TRACE SETUP (CONTINUED)
Control Function Related Section